How to use the Ultrasonic Beautifier.

Reduces fine lines, wrinkles, age spots, sun damage, redness, rosacea, acne, black heads, white heads, and tightens and tones problem areas.
Eliminates excess fat cells, lightens scaring.
Relieves soreness of muscles.
Removes excess active oxygen in the body.

 Use on clean skin.
Make sure power adapter is plugged into device. Push the power switch to L (for the face) or H (for the body).Wait one minute for the metal head to warm up. Plugs into any wall socket. Stay clear from water.
When the power is on (red light is lit up), slowly move the device in a circular motion on the skin. The device must stay in constant contact with the skin without applying too much pressure. Do not keep the metal head in one spot for longer than 5 seconds. Avoid using right on the eye area, genitals, open sores, or any areas that may have an infection.
Only use the device for 10 minutes at a time for each part of the body. Wait at least 10 hours between each use. If multiple users, wait five minutes before each use so that the metal head can cool down.
When device is not in use, remove from wall socket. Do not use over the sink. Do not immerse the ULTRASONIC BEAUTIFIER in water or clean with water. Always wipe the head and hand piece before and after each use with alcohol or disinfectant.

Frequently asked questions
1. How often should the ULTRASONIC BEAUTIFIER be used?
During the first 3-4 weeks, you should use the device daily for 10 minutes at a time. After about 4 weeks if you are satisfied with the current results, you may reduce use to 2-3 times a week. If using for pain relief of muscles, use when needed.
2. I don't feel anything when device is on, just a soft warming of the metal head. Is my device defective?
Definitely not! The vibration generator head produces ultrasonic waves with a frequency of 1MHz, that means one million times each second. The human senses are not able to recognize them, but you can make them visible by dropping a tiny bit of water on the metal head while the device is on. You will witness the water "dancing" and steaming.
3. I have the impression that my skin breaks out after the first few treatments. Is this suppose to happen?
In some circumstances, yes, this is possible because of the cleaning effect which helps to draw out impurities by breaking down bacteria.

IMPORTANT NOTICE

The device should not be used in a damp or moist room. Do not get wet. Clean before and after each use with an alcohol swab.

When the power is on, it is normal that the Ultrasonic vibration generator head will raise a little in temperature. If the head feels like it is over heating, turn device off immediately. When using the device, keep away from joints, eyelids, genital area or any area of the body that may contain silicon, rubber, or metal. If area being treated feels uncomfortable, stop use.

Do not use if you are pregnant.
Surgical scaring until three months have passed.
If you suffer from:
Heart problems
Injuries in the area being used
Areas of Dermatitis or Psoriasis
Lupus/ Diabetes/ Auto Immune Disease Use with caution.

Power Input: 120 Volt
10 Watts
Frequency: 10MHz








Vibrations of the ULTRASONIC BEAUTIFIER are invisible and cannot be felt on the skin's surface. The metal head moves as fast as 1 million times per second. Therefore, only a warming sensation is noticed. In order to see the metal head working, applying a couple drops of water will allow you to see it's effect. You will witness the water "dancing" and steaming.
The following effects are visible:
Deep cleaning
Improved blood perfusion and lymphatic  drainage
Elimination of pollutants and toxins
Oxygen activation
Synthesis of collagen

The ULTRASONIC BEAUTIFIER transmits waves deep below the skin's surface. The metal head moves so rapidly that it is invisible to the eye. Blood circulation is increased promoting metabolism while excess bacteria is broken down and removed, thus restoring skin's appearance.